• Users Online: 301
  • Home
  • Print this page
  • Email this page
Home About us Editorial board Ahead of print Current issue Search Archives Submit article Instructions Subscribe Contacts Login 
ORIGINAL ARTICLE
Year : 2016  |  Volume : 2  |  Issue : 1  |  Page : 29-34

A comparison of deformity correction capabilities in hexapod frame systems


1 Department of Orthopedics, Nemours Children's Hospital, Orlando, FL 32827, USA
2 Center for Excellence in Limb Lengthening and Reconstruction, Texas Scottish Rite Children's Hospital, Dallas, TX 75219, USA

Correspondence Address:
Christopher A Iobst
Nemours Children's Hospital, 13535 Nemours Parkway, Orlando, FL 32827
USA
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/2455-3719.182573

Rights and Permissions

Context: Hexapod fixators can be divided into two basic design groups. One group consists of frames that use ball and socket joint struts attached to the outer surface of the rings. The other group consists of frames that use cardan type universal joint struts attached to the under surface of the rings. Aims: To compare the ability of different hexapod fixator systems for deformity correction. Settings and Design: Nearly, identical two-ring frame constructs were compared to determine if there was any difference in deformity correction capability between cardan type universal joint struts and ball and socket joint struts. Materials and Methods: Maximal deformity was created using the software for each of the frame constructs in all six planes of deformity (angulation, translation, and rotation in the coronal and sagittal planes). Clinical scenarios were also compared (equinus contracture, moderate Blount disease, and severe Blount disease) and the number of strut changes necessary to correct the deformity were recorded. Results: For the small and medium-sized struts, the angular deformity corrections were similar, but the cardan type universal hinges had a greater capability for correcting translational deformity and rotation than the ball and socket joints. However, the amount of lengthening possible was greater for the ball and socket joints with these strut sizes. In the largest size of struts, the ball and socket joints had greater range in every category except rotation. In patients requiring significant rotational correction, the cardan type universal joints were found to impinge on the soft tissues 13° earlier than the ball and socket joints (39° vs. 52°). A Blount disease case with moderate multiplanar deformity and an equinus correction of 45° required the same amount of strut changes for each design. For the Blount disease case with severe multiplanar deformity, the cardan type universal joint struts required six total changes, whereas the ball and socket joint struts required only one strut change and two strut adjustments to achieve the same correction. Conclusions: Both the cardan type universal joint and the ball and socket joint hexapod frame designs allow substantial multiplanar corrections to occur. In the smaller size struts, the cardan type universal joints allow more translation and rotation, whereas the ball and socket joints allow more length. For large rotational corrections and frames built with 90° of offset, the ball and socket joint design is better at avoiding soft tissue impingement. While both systems are comparable with mild to moderate deformity correction, the ball and socket joint design allows more correction with less strut changes for patients with severe deformity in our experimental construct.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed1667    
    Printed123    
    Emailed1    
    PDF Downloaded20    
    Comments [Add]    
    Cited by others 3    

Recommend this journal